You will also need to secure the lattice sheet on the front of the post. Screw or nail through the channel to attach it to the deck boards. The channel also offers a capped look to the lattice sheet. The u-channel will help guide the lattice along the deck boards. The picture above shows the lattice on the front of the post with the use of the u-channel along the top of the lattice sheet. Don’t be overwhelmed with all the options. No need to predrill oversized holes for our lattice. You can either screw or nail through the lattice sheet to a support. You can put the lattice on the front of the support post, you can frame the lattice sheet and install on the front of the support post, use a u-channel or install the lattice without a u-channel. Ok, now on to the first installation example.ĭeck skirting has 4 common ways you can install the lattice. This will prevent the blade from chopping through the lattice sheet. Two when cutting our lattice with a circular saw, reverse the blade. This will prevent rust stains on your lattice. One use stainless steel nails or screws to secure your lattice sheets. If you have questions, please call us! Since Permalatt’s lattice can be used for so many projects there can be more than one way for installation.īefore we get into each project type we have a couple of suggestions. Please remember, you have options for your lattice installation. We’re going to share a few of our installation suggestions as well as ways our customers have installed our lattice in their projects. It seems the next topic is how to cut lattice. A partner can help to support the panel for you as you cut, which will make your job easier.When you Google lattice installation you may notice the first topic is lattice skirting. The panels must be supported along both sides if you want to cut neatly and safely. It helps to have somebody to help you as you cut. If not held down firmly, the lattice can split or tear. As you approach the end of a cut, be sure to support the panel firmly, especially at the cut line. Cut at a steady pace so the material doesn’t chip or crack. However, the “back” side should be up when a rotary saw is in use. Cut Correctlyīe sure the lattice “face” side is upward when a fine-toothed hard saw is in use. If you plan to make angled or curved cuts, use a power-saber saw. To cut vinyl lattice, attach a vinyl-cutting blade to the power saw. It also enables you to cut accurately and effectively. This will enable you to cut through the staples in the panels with ease. It is best to attach a carbide-tipped wood blade to the power saw for a wooden lattice. Use a power saw such as a circular saw or fine-toothed hard saw to cut the panels to size. Removing these staples first will reduce the risk for flying bits of staple when you cut the lattice. Try and remove as many of the staples as you can that are along the cut line. These grid panels have many staples that help to secure the lattice in place. Use a chalk line to indicate the cut line. Alternatively, cut the panels with a few inches of allowance that can extend into the ground. For installation on slopes, you must cut the panels to correspond with the grade. Allow an additional 1/4 inch on all sides of the panel to accommodate expansion and contraction. If the area to be framed isn’t square, it will be necessary to make extra cuts to enable the panels to fit properly. Doing so will ensure the panels fit properly into the framing and support posts. It is important to take accurate measurements of your project, especially the width.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |